Organizing the Manifold Pump wiring was a must so I used 20A 12 Position Terminal Blocks (cut to size) and ¼" Split Loom Tubing to accomplish the task.
	I wanted access to the wiring without having to remove the deck so I mounted the Terminal Blocks on the forward section of the Manifold Lid. This was accomplished by simply gluing them to the clear Lexan®. The positive wires are to starboard and the negative to port.
The ¼" Split Loom Tubing was not large enough to house all seven wires so I had to use two (2) sections of the tubing for each side. The red electrician´s tape is to keep the tubing together at the split.

If you have any suggestions or comments about this site or construction, please send me an email by clicking here!

Copyright © 2003 - 2012 John T. VanderHeiden
Last Updated Tuesday, April 13, 2004 2:45:13 AM