Here, you can see the installation rings indicating the location of the holes to be drilled.
|
|
To mark the centerline, I used a carpenter´s chalk line. And then, because the chalk would wipe off, I used a pencil and two strips of masking tape. |
|
I used the centerline as a reference point to position and mark the locations for my two (2) Graupner Voith-Schneider® Propulsion drives. Here, you can see the installation rings indicating the location of the holes to be drilled. |
|
|
|
I haven´t manufactured the decks yet, but the day was getting late ... too late to continue. Therefore, I decided to show off a little bit and display progress so far. |
| These are different views showing the hull and superstructure up to this point. |
|
|
|
|
| The next step in construction will be to manufacture the main deck and figure out how it will attach to the hull. Then, it will be time to cut the holes for the two (2) Graupner Voith-Schneider® Propulsion drives and remove the pink foam from the hull. |
|
If you have any suggestions or comments about this site or construction, please send me an email by clicking here!
Copyright © 2003 - 2008 John T. VanderHeiden
Last Updated Tuesday, December 23, 2003 5:42:54 PM